Ensure that you have completed the following tasks before you start the installation:
Verify that your hardware and software meet the system requirements listed in Section 5.0, Meeting System Requirements.
If there was a previous installation of Sentinel, ensure that there are no files or system settings remaining from a previous installation. For more information, see Section C.0, Uninstalling.
If you plan to install the licensed version, obtain your license key from the Novell Customer Care Center.
Ensure that the ports listed in Section 7.0, Ports Used are opened in the firewall.
For the Sentinel installer to work properly, the system must be able to return the hostname or a valid IP address. To do this, add the hostname to the /etc/hosts file to the line containing the IP address, then enter hostname -f to make sure that the hostname is displayed properly.
Synchronize time by using the Network Time Protocol (NTP).
On RHEL systems: For optimal performance, the memory settings must be set appropriately for the PostgreSQL database. The SHMMAX parameter must be greater than or equal to 1073741824.
To set the appropriate value, append the following information in the /etc/sysctl.conf file:
# for Sentinel Postgresql kernel.shmmax=1073741824
For traditional installations:
Ensure that IPv6 is enabled in your operating system. If IPv6 is not enabled, major components will fail to operate.
The operating system for the Sentinel server must include at least the Base Server components of the SLES server or the RHEL 6 server. Sentinel requires the 64-bit versions of the following RPMs:
bash
bc
coreutils
gettext
glibc
grep
libgcc
libstdc
lsof
net-tools
openssl
python-libs
sed
zlib