1.7 Global Settings

Use global settings to configure the mapping of Administration Console(s) Private IP address to Public NAT IP address.

The devices that cannot reach the Private Administration Console IP address use the NAT IP address. You must specify the NAT IP Addresses prior to importing devices.

You can perform the following activities by using the following global settings:

1.7.1 Creating a New NAT IP Address Mapping

To create new IP address,

  1. Log in to Access Manager.

  2. Go to Access Manager > Access Manager > Global Settings, then click New.

  3. Select an IP address from the Administration Console Public IP Address drop-down list.

  4. Enter the Public NAT IP Address.

    NOTE:If NAT IP address is not provided or if a mapping already exists for the selected Administration Console IP, IP Address is not valid message is displayed.

  5. To continue, click OK, then click Apply Changes.

  6. Click Cancel to exit.

1.7.2 Removing a NAT IP Address Mapping

To remove an existing IP address,

  1. Log in to Access Manager.

  2. Go to Access Manager > Access Manager > Global Settings, then select the IP address check box you want to delete.

  3. Click Delete, then click OK.

1.7.3 Viewing the NAT IP Address Mapping

To view the newly created and existing IP address,

  1. Log in to Access Manager.

  2. Go to Access Manager > Access Manager > Global Settings to view the list of already configured Physical IP addresses and NAT IP addresses.

  3. Create New if the list does not contain any Physical IP Address and NAT IP Address entries.

    Physical IP Address: Specifies the physical private IP Address for the Administration Console.

    Public NAT IP Address: Specifies the Public NAT IP Address. You can configure or map the NAT IP Address.

  4. Click Close.

1.7.4 Editing a NAT IP Address Mapping

To edit the existing IP address,

  1. Log in to Access Manager.

  2. Go to Access Manager > Access Manager > Global Settings, then click on the Public NAT IP Address hyperlink.

  3. Enter the new Public NAT IP Address.

  4. Click OK to continue or click Cancel to exit.