4.1 Installing Windows Client

To install Windows Client with the setup wizard, perform the following steps:

  1. Navigate to System > properties (Control Panel > All Control Panel Items > System) to identify your System type.

  2. Run naaf-winclient-x86-release-<version>.msi for a 32-bit operating system or naaf-winclient-x64-release-<version>.msi for a 64-bit operating system.

    To install Windows Client Support Assisted Logon mode, run the following command:

    msiexec -i naaf-winclient-x86|x64-release-<version>.msi ASSISTANCE_LOGON=1.

  3. Click Next.

  4. Accept the License Agreement and click Next.

  5. Click Next to install on the default folder or click Browse to select a different folder.

  6. Click Install.

  7. Click Finish.

    NOTE:If you are installing Windows Client on a non-domain workstation or when Advanced Authentication as a Service is used, create a configuration file C:\ProgramData\NetIQ\Windows Client\config.properties before you restart the system and follow the procedure in the section Using a Specific Advanced Authentication Server in a Non-Domain Mode to specify an Advanced Authentication server.

    NOTE:If the Windows Client installation hangs or fails, this might be due to the unavailability of a port for the Windows Client Cache Service. To resolve this issue, you can configure a specific port that manages the Windows Client Cache Service. For more information, see Configuring the Port for Windows Client Cache Service.