2.5 Mapping the Private IP Address to Public IP Address

Use Global Settings to configure mapping of the Administration Console private IP address to public NAT IP address.

Devices that cannot reach the private Administration Console IP address use the NAT IP address. You must specify the NAT IP addresses prior to importing devices.

You can perform the following activities by using Global Settings:

2.5.1 Creating a New NAT IP Address Mapping

In the Administration Console Dashboard, click icon at the top right of the page and then click Global Settings > New.
Select an IP address from the Administration Console Public IP Address list.
Specify the Public NAT IP Address.
NOTE:If NAT IP address is not provided or if a mapping already exists for the selected Administration Console IP, this message is displayed:
```
IP Address is not valid
```
To continue, click OK, then click Apply Changes.
Click Cancel to exit.

2.5.2 Removing a NAT IP Address Mapping

In the Administration Console Dashboard, click icon at the top right of the page and then click Global Settings
Select the IP address you want to delete.
Click Delete, then click OK.

2.5.3 Viewing the NAT IP Address Mapping

In the Administration Console Dashboard, click icon at the top right of the page and then click Global Settings. You can see the list of already configured physical IP addresses and NAT IP addresses.
Create New if the list does not contain any Physical IP Address and NAT IP Address entries.

Physical IP Address: Specifies the physical private IP Address for the Administration Console.

Public NAT IP Address: Specifies the Public NAT IP Address. You can configure or map the NAT IP Address.
Click Close.

2.5.4 Editing a NAT IP Address Mapping

In the Administration Console Dashboard, click icon at the top right of the page and then click Global Settings.
Click Public NAT IP Address.
Specify the new Public NAT IP Address.
Click OK.