NetIQ Module: Log Manager for Third Brigade Deep Security |
Supported Products
|
Date Published
|
Log Manager for Third Brigade Deep Security allows you to collect, evaluate, and present data collected by a Third Brigade Deep Security solution.
Log Manager for Third Brigade Deep Security provides support for Third Brigade Deep Security Manager 5.1 and Deep Security Agent 5.0.
Improvements are made in direct response to suggestions from our customers. We thank you for your time and valuable input. We hope you continue to help us ensure our products meet all your needs.
The following table lists additional requirements for a Windows agent monitoring Third Brigade Deep Security. For more information about agent requirements, see the Installation Guide for NetIQ Security Manager.
Category | Requirement |
---|---|
Processor | 1.5 GHz Intel Pentium III or equivalent. |
Memory | 40 MB minimum. The amount of memory usage varies and depends on the environment, including event rate and other factors. Memory use for a Windows agent monitoring Third Brigade Deep Security Manager could reach 256 MB or higher. |
Operating System | All supported Windows agent platforms. |
Software |
|
You can install this module using the Module Installer. After you install the module, run the Configuration Wizard to configure the module. For more information about installing and configuring this module, see the NetIQ Security Manager for Third Brigade Deep Security Monitoring Guide in the following folder on the user interface computer:
installation folder\NetIQ Security Manager\OnePoint\Documentation\Monitoring Guides
Where installation folder is the location where you installed Security Manager user interfaces.
© 2004 - 2008 NetIQ Corporation. All rights reserved. |