Running a Test Suite

On the home page of the console, click Command Control.

In the details pane, click Test Suites.

Select the required test suite.

To select multiple test suites, press the Ctrl key and select the required test suites one at a time, or press the Shift key to select a consecutive list of test suites. Use Ctrl+A to select all test suites.

Click Run Test Suites in the task pane. The results are displayed for each test case as Success or as Failure, along with the reason for the failure.

Use the buttons on the left and right of the table to find previous successes and failures, and the next successes and failures.

To view further details on a specific entry, select the entry and click Details.

The configuration for the test case is shown, and a list of rules that have been tested, with configuration settings for each rule. The Matched column shows true if the rule conditions were met, and false if the rule conditions were not met.

Click Back to return to the main Run Test Suite page.

Click Cancel to return to the list of test suites.