4.5 Device Is Not Reachable After Migrating From the 3.1 SP4 Access Gateway Appliance to Access Gateway Appliance

After migrating, Yast adds the default route through second interface if both the NIC interfaces are on the same subnet.

To workaround this issue, perform the following steps:

  1. Go to YaST > Network Devices > Network Settings > Routing and remove the default gateway.

  2. Select Add in the Routing Table and enter the following details:

    Destination: Enter the destination IP address 0.0.0.0.

    Device: Enter the device id eth0.

    Gateway: Enter the default gateway IP address.

    Netmask: Enter the netmask address 0.0.0.0.

  3. Click OK and Quit. If the service provider does not start successfully perform the workaround provided in Section 4.6, Service Provider Does Not Start.