The Identity Vault Data Sources page allows you to configure settings for the managed systems (referred to as connected systems in earlier releases of Identity Manager) that you want to report on, and provide information about where the reporting module can find the Identity Vaults associated with these managed systems. The reporting module can work with data sources for one or more Identity Vaults. Each Identity Vault you work with on this page must have a separate registration for each of the following drivers:
Identity Manager Driver for Data Collection Service
Identity Manager Managed System Gateway Driver
To define the Identity Vault settings:
Click
under in the left navigation menu.The reporting module displays the Identity Vault Data Sources page:
If you have more than one Identity Vault registration, you might need to scroll down to see the other Identity Vaults.
Provide details about each Identity Vault you want to configure, as follows:
Driver |
Identity Vault Setting |
Description |
---|---|---|
|
|
The network address of the Identity Vault. (Read only) |
|
The name given to the Data Collection Service Driver. (Read only) |
|
|
Controls whether the Data Collection Service Driver collects event data for this data source. Ordinarily, this check box should be enabled, unless you need to shut down event collection in order to perform a system maintenance procedure that might conflict with the collection of data. |
|
|
|
Indicates whether the data source is running or suspended. You can use the and buttons to control the data source state. |
|
The user name required to authenticate to the driver. (Read only) |
To save your changes, click
.To start the data source for the Managed System Gateway Driver, click
to the right of :The first time you activate data collection, the state is shown as
, rather than .To stop a running data source, click
: