IMPORTANT:Check the currently installed Novell and Third Party applications to determine if eDirectory 8.8 is supported before upgrading your existing eDirectory environment. You can find out the current status for Novell products in the TID 7003446 It is also highly recommended to back up eDirectory prior to any upgrades.
Because NTFS provides a safer transaction process than a FAT file system provides, you can install eDirectory only on an NTFS partition. Therefore, if you have only FAT file systems, do one of the following:
Create a new partition and format it as NTFS.
Use Disk Administrator. Refer to the Windows Server documentation for more information.
Convert an existing FAT file system to NTFS, using the CONVERT command.
Refer to the Windows Server documentation for more information.
If your server only has a FAT file system and you forget or overlook this process, the installation program prompts you to provide an NTFS partition.
(Conditional) NICI 2.7 and eDirectory 8.8 support key sizes up to 4096 bits. If you want to use a 4 KB key size, every server must be upgraded to eDirectory 8.8. In addition, every workstation using the management utilities, for example, iManager and ConsoleOne, must have NICI 2.7 installed on it.
When you upgrade your Certificate Authority (CA) server to eDirectory 8.8, the key size will not change but will still be 2 KB. The only way to create a 4 KB key size is recreate the CA on an eDirectory 8.8 server. In addition, you would have to change the default from 2 KB to 4 KB for the key size, during the CA creation.
NOTE:The Windows Silent Installer requires NICI installed on the system.
If you are upgrading to eDirectory 8.8, make sure you have the latest eDirectory patches installed on all non-eDirectory 8.8 servers in the tree. You can get eDirectory patches from the Novell Support Web site.
Make sure you have the latest Windows 2003 or 2008 Server Service Packs installed. The latest updated Windows Service Pack needs to be installed after the installation of the Windows SNMP service.
If you are upgrading from a previous version of eDirectory, it must be eDirectory 8.7.3 or later.
(Conditional) If you are installing a secondary server into an existing tree as a non-administrator user, ensure that you have the following rights:
Supervisor rights to the container the server is being installed into.
Supervisor rights to the partition where you want to add the server.
NOTE:This is required for adding the replica when the replica count is less than 3.
All Attributes rights: read, compare, and write rights over the W0.KAP.Security object.
Entry rights: browse rights over Security container object.
All Attributes rights: read and compare rights over Security container object.
(Conditional) If you are installing a secondary server into an existing tree as a non-administrator user, ensure that at least one of the servers in the tree has the same or higher eDirectory version as that of the secondary being added as container admin. In case the secondary being added is of later version, then the schema needs to be extended by the admin of the tree before adding the secondary using container admin.
While configuring eDirectory, you must enable SLP services and an NCP port (the default is 524) in the firewall to allow the secondary server addition. The NCP port must be configured to allow both inbound and outbound traffic.
Additionally, you can enable the following service ports, based on your requirements:
LDAP clear text - 389
LDAP secured - 636
HTTP clear text - 8028
HTTP secured - 8030
If you have enabled user-defined ports, you must specify these ports while configuring eDirectory.
If you are installing eDirectory on a virtual machine having a DHCP address or on a physical or virtual machine in which SLP is not broadcast, ensure that the Directory Agent is configured in your network.
Static IP address must be configured on the server for the eDirectory to perform efficiently. Configuring eDirectory on the servers with DHCP address can lead to unpredictable results.