Use this Knowledge Script to monitor the operational status of disk partitions, called logical drives, on HP or Dell computers running Linux. The script raises an event if a monitored logical drive is in a state other than one of the states that you specify to be operational states. The script can also report events based on error conditions that occur when the software is not properly installed, configured, or running.
For information about logical drive object properties, see Section 5.1.2, LogicalDrive Properties.
If you are monitoring Dell equipment, this Knowledge Script requires OMSA components on the computer you are monitoring. You can install these components using the srvadmin-all meta package.
If you are monitoring HP equipment, this Knowledge Script requires the HP Array Configuration Utility CLI for Linux and HP System Health Application and Command Line Utilities for Linux installed on the computer you are monitoring.
Any logical disk or disks on an HP or Dell computer running Linux
The default interval for this script is Every 15 minutes.
Set the following parameters as needed:
|
Description |
How to Set It |
|---|---|
|
Event Settings |
|
|
Event severity when job fails |
Specify the event severity level, from 1 to 40, to indicate the importance of the event. The default is 5. |
|
Raise event when AppManager fails to get logical drive metrics ? |
Set to Yes to raise an event if AppManager cannot collect any information about the logical drive. The default is yes. |
|
Event severity |
Specify the event severity level, from 1 to 40, to indicate the importance of the event. The default is 5. |
|
Raise event when logical drive is not functional? |
Set to Yes to raise an event if the logical drive is in any state other than the states that you specify as functional. You specify which states are considered functional using the parameter Comma-separated list of fully functional states. The default is yes. |
|
Event severity |
Specify the event severity level, from 1 to 40, to indicate the importance of the event. The default is 5. |
|
Raise event when logical drive is fully functional? |
Set to Yes to raise an event if the logical drive is in a state that you specify as functional. You specify which states are considered functional using the parameter Comma-separated list of fully functional states. The default is no. |
|
Event severity when logical drive is fully functional |
Specify the event severity level, from 1 to 40, to indicate the importance of the event. The default is 25. |
|
Comma-separated list of fully functional status |
Specify one or more states that you want AppManager to consider functional. If you specify more than one state, separate them with commas and no spaces. For example, locked,unassigned. The default is OK. |