4.54 Transcoder_Device

Use this Knowledge Script to monitor the usage of registered transcoder devices. This script raises an event if a threshold is exceeded. In addition, this script generates data streams for the number of active resources and for resource usage (%).

4.54.1 Resource Object

CiscoCM_XCode_DeviceObj

4.54.2 Default Schedule

By default, this script runs every 15 minutes.

4.54.3 Setting Parameter Values

Set the following parameters as needed:

Parameter

How to Set It

General Settings

Job Failure Notification

Event severity when job fails

Set the event severity level, from 1 to 40, to indicate the importance of the failure of the Transcoder_Device job. The default is 5.

Monitor Resource Usage

Event Notification

Raise event if resource usage exceeds threshold?

Select Yes to raise an event if the percentage of transcoder device usage exceeds the threshold that you set. The default is Yes.

Threshold - Maximum resource usage

Specify the highest percentage of transcoder device usage that must occur before an event is raised. The default is 80%.

Event severity when resource usage exceeds threshold

Set the event severity, from 1 to 40, to indicate the importance of an event in which the percentage of transcoder usage exceeds the threshold you set. The default is 15.

Data Collection

Collect data for resource usage?

Select Yes to collect data for charts and reports. If enabled, data collection returns the percentage of transcoder usage at each script iteration. The default is unselected.

Monitor Active Resources

Data Collection

Collect data for active resources?

Select Yes to collect data for charts and reports. If enabled, data collection returns the number of transcoder devices that are active at each script iteration. The default is unselected.

Monitor Unavailable Resources

Event Notification

Raise event if number of times resources were unavailable exceeds threshold?

Select Yes to raise an event if the number of times that transcoder devices were unavailable exceeds the threshold that you set. The default is Yes.

Threshold - Maximum number of times resources were unavailable

Specify the maximum number of times that transcoder devices can be unavailable before an event is raised. The default is 0 instances.

Event severity number of times resources were unavailable exceeds threshold

Set the event severity, from 1 to 40, to indicate the importance of an event in which the number of times that transcoder devices were unavailable exceeds the threshold you set. The default is 15.

Data Collection

Collect data for number of times resources were unavailable?

Select Yes to collect data for charts and reports. If enabled, data collection returns the number of times that transcoder devices were unavailable during the monitoring period. The default is unselected.