4.39 MGCP_T1CAS_ChannelHealth

Use this Knowledge Script to monitor the status of channels for an MGCP T1CAS (Media Gateway Control Protocol Channel Associated Signaling) device. This script raises an event if a channel is not available.

4.39.1 Resource Object

CiscoCM_MGCPT1CASObj

4.39.2 Default Schedule

By default, this script runs every two minutes.

4.39.3 Setting Parameter Values

Set the following parameters as needed:

Parameter	How to Set It
General Settings
Job Failure Notification
Event severity when job fails	Set the event severity level, from 1 to 40, to indicate the importance of the failure of the MGCP_T1CAS_ChannelHealth job. The default is 5.
Monitor T1CAS Channels
Select T1CAS channels to monitor	Select one or more T1CAS channels to monitor. To monitor all channels, select All. To monitor selected channels, press [Ctrl] while clicking on the channels you want.
Treat unknown channel status as out-of-service?	Select Yes to classify as out-of-service any selected channel whose status is unknown. The default is unselected. An out-of-service channel will trigger this script to raise an event.
Event Notification
Raise event if channel is not available?	Select Yes to raise an event if the selected T1CAS channels are not available. The default is Yes.
Event severity when channel is not available	Set the event severity level, from 1 to 40, to indicate the importance of an event in which the selected T1CAS channels are not available. The default is 5.