Use this Knowledge Script to monitor the status of channels for an MGCP PRI (Media Gateway Control Protocol Primary Rate Interface) device. This script raises an event if a channel is not available.
CiscoCM_MGCPPRIObj
By default, this script runs every two minutes.
Set the following parameters as needed:
Parameter |
How to Set It |
---|---|
General Settings |
|
Job Failure Notification |
|
Event severity when job fails |
Set the event severity level, from 1 to 40, to indicate the importance of the failure of the MGCP_PRI_ChannelHealth job. The default is 5. |
Monitor PRI Channels |
|
Select PRI channels to monitor |
Select one or more PRI channels to monitor. To monitor all channels, select All. To select individual channels in the list, press [Ctrl] while clicking on the channels you want. To select an entire range of channels, press [Shift] while clicking on the first and last channel in the range. The default is All. |
Treat unknown channel status as out-of-service |
Select Yes to classify as out-of-service any selected channel whose status is unknown. The default is unselected. An out-of-service channel will trigger this script to raise an event. |
Event Notification |
|
Raise event if channel is not available? |
Select Yes to raise an event if the selected PRI channels are not available. The default is Yes. |
Event severity when channel is not available |
Set the event severity level, from 1 to 40, to indicate the importance of an event in which at least one of the selected PRI channels is not available. The default is 5. |