Use this Knowledge Script to monitor active ports, out-of-service ports, and outbound busy attempts for analog access gateways. This script raises an event if a threshold is exceeded. In addition, this script generates data streams for active ports, out-of-service ports, and outbound busy attempts.
CiscoCM_AnalogAccessObj
By default, this script runs every 15 minutes.
Set the following parameters as needed:
Parameter |
How to Set It |
---|---|
General Settings |
|
Job Failure Notification |
|
Event severity when job fails |
Set the event severity level, from 1 to 40, to indicate the importance of the failure of the AnalogAccess_GatewayUsage job. The default is 5. |
Monitor Active Ports |
|
Event Notification |
|
Raise event if active ports exceed threshold? |
Select Yes to raise an event if the number of active ports exceeds the threshold you set. The default is Yes. |
Threshold - Maximum active ports |
Specify the maximum number of ports that can be active before an event is raised. The default is 20 ports. |
Event severity when active ports exceed threshold |
Set the event severity level, from 1 to 40, to indicate the importance of an event in which the number of active ports exceeds the threshold. The default is 15. |
Data Collection |
|
Collect data for active ports? |
Select Yes to collect data for charts and reports. If enabled, data collection returns the number of ports that are active at each script iteration. The default is unselected. |
Monitor Busy Attempts |
|
Event Notification |
|
Raise event if busy attempts exceed threshold? |
Select Yes to raise an event if the number of times that the gateway received a busy signal exceeds the threshold you set. The default is Yes. |
Threshold - Maximum busy attempts |
Specify the maximum number of times the gateway can attempt a connection that receives a busy signal before an event is raised. The default is 0 attempts. |
Event severity when busy attempts exceed threshold |
Set the event severity level, from 1 to 40, to indicate the importance of an event in which the number of busy attempts exceeds the threshold. The default is 15. |
Data Collection |
|
Collect data for busy attempts? |
Select Yes to collect data for charts and reports. If enabled, data collection returns the number of gateway connection attempts that received a busy signal during the monitoring period. The default is unselected. |
Monitor Out of Service Ports |
|
Event Notification |
|
Raise event if out of service ports exceed threshold? |
Select Yes to raise an event if the number of ports that were out of service exceeds the threshold you set. The default is Yes. |
Threshold - Maximum out of service ports |
Specify the maximum number of ports that must be out of service before an event is raised. The default is 0 ports. |
Event severity when out of service ports exceed threshold |
Set the event severity level, from 1 to 40, to indicate the importance of an event in which the number of out-of-service ports exceeds the threshold. The default is 15. |
Data Collection |
|
Collect data for out of service ports? |
Select Yes to collect data for charts and reports. If enabled, data collection returns the number of ports that are out of service at each script iteration. The default is unselected. |