4.4 Verifying Access Gateway Installation

  1. Log in to Administration Console.

    See Section 2.3, Logging In to Administration Console.

  2. Click Devices > Access Gateways.

    If the installation was successful, the IP address of your Access Gateway appears in the Server list.

    The Health status indicates the health state after Access Gateway is imported and registers with Administration Console.

    NOTE:Access Gateway Appliance health is displayed as green instead of yellow, even before a trust relationship is established between an Embedded Service Provider and Access Gateway. You must establish a trust relationship with Administration before you proceed with any other configuration.

    If an Access Gateway starts to import into Administration Console but fails to complete the process, the following message appears:

    Server gateway-<name> is currently importing. If it has been several minutes after installation, click repair import to fix it.

    If you have waited at least ten minutes, but the message doesn’t disappear and Access Gateway does not appear in the list, click the repair import link.