ME wrote: Using PlateSpin Forge, what is the lowest continuous RPO I can achieve at a remote site?

A. There are several factors involved here, primarily the amount of bandwidth that you have available, as well as the total changed data being written during each incremental.

The process you go through to prep the target VM for a data write takes approximately 5-10 minutes. So in the best case scenario — with unlimited bandwidth and a tiny disk write — the lowest RPO would be about 10 minutes. However, we usually try to be a bit more conservative when asked this question and say about 30 minutes.

0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this post.
Categories: Uncategorized

Disclaimer: As with everything else at NetIQ Cool Solutions, this content is definitely not supported by NetIQ, so Customer Support will not be able to help you if it has any adverse effect on your environment.  It just worked for at least one person, and perhaps it will be useful for you too.  Be sure to test in a non-production environment.

Leave a Reply

No Comments
By: coolguys
Apr 12, 2011
3:20 pm
Active Directory Authentication Automation Cloud Computing Cloud Security Configuration Customizing Data Breach DirXML Drivers End User Management Identity Manager Importing-Exporting / ICE/ LDIF Intelligent Workload Management IT Security Knowledge Depot LDAP Monitoring Open Enterprise Server Passwords Reporting Secure Access Supported Troubleshooting Workflow